 |
07-13-2006, 12:43 AM
|
|||
|
|||
No Spark..What should i do?
i first recieved a misfire code in my 3rd cylinder so i began going through the motions, replacing fuel filter, spark plugs, wires..etc. then i got a mass air flow sensor reading so i replaced that. The cylinder 3 misfire never went away but i got a code reading my crankshaft position sensor was done along with a coolant reading and a shift solenoid reading. At this point my car would not accelerate over 2000rpms. i replaced the sensor but in the process my car stop firing up. it turns over just fine but there is no spark. Nothing seems off such as the plugs or wires but i tested the wires to the coil pack and there is no spark on any of the coils. Does any one know what i should do to get spark?
    
|
|
07-13-2006, 12:55 PM
|
||||
|
||||
|
Have you tried replacing the coil packs?
__________________
K&N air filter Alpine V12 amp JL Audio 12W3v2 12" subwoofer MSD 8.5mm SuperConducter wires Dynomax Super Turbo exhaust
|
|
07-15-2006, 08:59 PM
|
|||
|
|||
|
are you getting gas? the ICM (ignition control module) controls the spark and the power to the fuel injectors, it is so easy to pop the fuse for it, check the fuse, it's a 5 amp.
__________________
My lugnuts require more torque than your Prelude produces!
|
|
08-26-2006, 12:00 PM
|
|||
|
|||
|
There is a crankshaft relearn for it so i would deffinately try that and see what happens
|
Linear Mode
